• DRA3.5 - 3.5″x.120 DOM Aluminum Driveshaft | 60″ or less Dim A

    $475.00
    Free Shipping!
    Specify Type Of Rear End
    Specify Transmission Spline Or Any Other Specifics
    Specify U-Joint Size For "D" & "E"
    Seal To Center Measurement

    Product Description

    Aluminum shafts are desired in many Hot Rod applications for appearance.   The U-joint Series choice becomes more critical over 500 HP, care must be taken to insure the correct U-joint is matched to the HP.

    Aluminum shafts are built under the most Stringent Tolerances in the industry.   Tubing is Factory Straightened to .010″ total runout at the center of the tube.  Tube yokes are welded to within .006″ runout on each end.  The shafts are Electronically Computer Balanced to less than 1/8 Oz/Inch.

    Shafts are complete with the most common standard transmission Slip Yokes.  In some cases an upgrade on the Slip Yoke or U- joints may be considered.  This is a good application for 1000HP applications. 

    THIS ITEM SHIPS FOR FREE & COMES WITH A  FORGED YOKE.